Another day, I just don’t know if I am making the right steps. I made the curved sanding bars and began on the edges. I really didn’t like the pressure/vibration that this method put into the sides. Not using a full external mold, I don’t feel there is enough support.
I found that the sanding “rolled” up hill at the blocks, leaving a peak and that the sanding was uneven. I am not convinced on the curved board method. I did not
Next build I will take the time and effort to construct an external mold.
This afternoon, I glued the kerfing to the back, tomorrow will be the front and then I’ll start on the braces.
Time taken : 3 hours
Tools used : sanding curve, rulers, chisel, pencils, chalk, clamps
AU$'s spent : nil
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment